Horizon / Plein textes La base de ressources documentaires de l'IRD

IRD

Publications des scientifiques de l'IRD

Leon J.G., Seyler Frédérique, Calmant Stéphane, Bonnet M.P., Cauhopé Mathilde. Hydrological parameter estimation for ungauged basin based on satellite altimeter data and discharge modeling. A simulation for the Caqueta River (Amazonian Basin, Colombia). Hydrology and Earth System Sciences Discussions, 2006, 3 (5), 3023-3059

En Libre Accès sur HAL http://hal.archives-ouvertes.fr/hal-00330792/en/

Titre
Hydrological parameter estimation for ungauged basin based on satellite altimeter data and discharge modeling. A simulation for the Caqueta River (Amazonian Basin, Colombia)
Année de publication2006
Type de documentArticle
AuteursLeon J.G., Seyler Frédérique, Calmant Stéphane, Bonnet M.P., Cauhopé Mathilde.
SourceHydrology and Earth System Sciences Discussions, 2006, 3 (5), 3023-3059
RésuméThe main objective of this paper is to review the usefulness of altimetric data in ungauged or very poorly monitored basin. It is shown that altimetric measurements can be combined with a single in-situ gauge to derive a reliable stage-discharge relationship upstream from the gauge. The Caqueta River in the Colombian Amazon Basin was selected to simulate a poorly monitored basin. Thus it was possible to derive the stage-discharge relationship for 13 "virtual gauge stations' defined at river crossing with radar altimetric ground tracks. Stage measurements are derived from altimetric data following the methodology developed by Leon et al. (2006). Discharge is modeled using PROGUM - a flow routing model based on the Muskingum Cunge (M-C) approach considering a diffusion-cum-dynamic wave propagation (Leon et al., 2006) using a single gauge located downstream from the basin under study. Rating curve parameters at virtual stations are estimated by fitting with a power law the temporal series of water surface altitude derived from satellite measurements and the modelled discharges. The methodology allows the ellipsoidal height of effective zero flow to be estimated. This parameter is a good proxy of the mean water depth from which the bottom slope of the reaches can be computed. Validation has been conducted by comparing the results with stages and discharges measured at five other gauges available on the Caqueta basin. Outflow errors range from 10% to 20% between the upper basin and the lower basin, respectively. Mean absolute differences less than 1.10 m between estimated equivalent water depth and measured water depth indicates the reliability of the proposed method. Finally, a 1.2×10<sup>-4</sup> mm<sup>-1</sup> mean bottom slope has been obtained for the 730 km long reach of the Caqueta main stream considered.
Plan de classement062
Descr. géo.COLOMBIE
LocalisationFonds IRD
Identifiant IRDPAR00002839
Lien permanenthttp://www.documentation.ird.fr/hor/PAR00002839

Export des données

Accès direct

Bureau du chercheur

Site de la documentation

Espace intranet IST (accès réservé)

Suivi des publications IRD (accès réservé)

Mentions légales

Services Horizon

Poser une question

Consulter l'aide en ligne

Déposer une publication (accès réservé)

S'abonner au flux RSS

Voir les tableaux chronologiques et thématiques

Centres de documentation

Bondy

Montpellier (centre IRD)

Montpellier (MSE)

Cayenne

Nouméa

Papeete

Abidjan

Dakar

Niamey

Ouagadougou

Tunis

La Paz

Quito